Really nice size. Super easy to get in & out, but watch your head on the wing. The additional width will make it a lot more comfortable than my legacy Sonex. "Bubble" doors won't really help this design much, as the center of the bubble is well ahead of your elbows, and your elbows are back near the door frame. Look at this compared with a Rans S-21, for example, where the widest part of the bubble door is right at your elbow. Seat angle and cushions were excellent. Lots of room in the panel. The dihedral is built into the center section, so the outer wing panel joint is exactly flat (wasn't sure whether the dihedral would occur at the wing outer panel joints). Also did the factory tour. This is all that there is at this point, but what's there so far looks really good! There was a pair of wing outer panels sitting in a rack in the factory - but they're for the 2-place jet. They were VERY tentatively forecasting flight before the end of the year, with maybe deposits (small $ to hold a place in line) towards the end of the year, with MAYBE tail kits early '25. But don't hold them to all that, as there's a whole flight test program to get through, and any updates out of that need to be proven in.