Vertical Tail Main Spar Assembly

[BobDz]

Working on my Main Spar Assembly.

I do not see torque values called out on the plan for the AN3 bolts. Using AC43.13-1B, Table 7-1, I come up with 12-15 inch pounds.

Is my thinking correct?

Thanks in advance.

[Bryan Cotton]

Bob,
That sounds right. I used to have a torque table on my old phone that I downloaded from the Van's forum. One thing to remember is to add the running torque to the recommended values for non-locking stuff. See:
https://vansairforce.net/community/show ... hp?t=80363

[BobDz]

Thanks Bryan

[Murray Parr]

10-32 is fine thread series standard type nut. The torque table shows 20-25 inch pounds for those, just measure how much drag the nyloc adds and add that to the lower. I think the value you have is for shear type nuts.

[BobDz]

Thanks Murray.i did catch my mistake before assembly .

[SonexYo]

I've been using this chart.

-johan

Torque.png (58.15 KiB) Viewed 1220 times