Wildly Fluctuating Oil Pressure

Discussion of the Aerovee kit engine.

Re: Wildly Fluctuating Oil Pressure

Postby mike.smith » Sat Sep 24, 2022 9:05 am

SUCCESS!!

The issue appears to be that the OP relief valve springs had worn out. I ordered new plungers/springs, and when I compared the original springs that I took out, to the new springs, the new ones were nearly an inch longer! So the old springs had lost enough strength to hold the plungers against the oil pressure, allowing the pressure to drop.

So add this to the collective VW memory banks!
Mike Smith
Sonex N439M
Scratch built, AeroVee, Dual stick, Tail dragger
http://www.mykitlog.com/mikesmith
mike.smith
 
Posts: 1430
Joined: Tue Jan 29, 2013 8:45 pm

Re: Wildly Fluctuating Oil Pressure

Postby Bryan Cotton » Sat Sep 24, 2022 9:08 am

Excellent! Thanks Mike for the info.
Bryan Cotton
Poplar Grove, IL C77
Waiex 191 N191YX
Taildragger, Aerovee, acro ailerons
dual sticks with sport trainer controls
Prebuilt spars and machined angle kit
Year 2 flying and approaching 200 hours December 23
User avatar
Bryan Cotton
 
Posts: 5489
Joined: Mon Jul 01, 2013 9:54 pm
Location: C77

Re: Wildly Fluctuating Oil Pressure

Postby Jerry09w » Sun Sep 25, 2022 9:45 am

The Aerovee has 2 pressure releif valves, one front and oe rear. You may want to make sure the long spring did not get put in the back, that would do away with the bypass for the top mount oil cooler if it gets plugged or very cold which could cause low oil pressure even it the pump is working OK. If they had been reversed that would also explain the short spring in the front relief valva. Check page 13 of the aerovee manual.
Jerry
Jerry09w
 
Posts: 32
Joined: Thu Sep 28, 2017 6:50 pm
Location: Fruita Colorado

Re: Wildly Fluctuating Oil Pressure

Postby mike.smith » Mon Sep 26, 2022 11:11 pm

Jerry09w wrote:The Aerovee has 2 pressure releif valves, one front and oe rear. You may want to make sure the long spring did not get put in the back, that would do away with the bypass for the top mount oil cooler if it gets plugged or very cold which could cause low oil pressure even it the pump is working OK. If they had been reversed that would also explain the short spring in the front relief valva. Check page 13 of the aerovee manual.
Jerry


Nope, not that. If you tried to put the long spring in the back you'd never get the retaining plug in. So it becomes pretty obvious they are reversed.
Mike Smith
Sonex N439M
Scratch built, AeroVee, Dual stick, Tail dragger
http://www.mykitlog.com/mikesmith
mike.smith
 
Posts: 1430
Joined: Tue Jan 29, 2013 8:45 pm

Previous

Return to Aerovee

Who is online

Users browsing this forum: No registered users and 33 guests