Discussion for builders, pilots, owners, and those interested in building or owning a second generation Sonex or Waiex.
by lakespookie » Sat Jul 03, 2021 10:08 pm
Hey everyone, hoping I can borrow some knowledge and not have to go through a bunch of trial and error but which reamers did you guys and gals use for the bell crank assemblies in particular for the presss fit bushings and also for the inside of the oil impregnated bushings.
Thanks
-
lakespookie
-
- Posts: 260
- Joined: Wed Aug 07, 2019 2:39 pm
- Location: San Diego California
-
by lakespookie » Sun Jul 04, 2021 2:22 am
I just saw on the plans where it says the OD and ID i feel like an idiot sorry about the dumb question.
-
lakespookie
-
- Posts: 260
- Joined: Wed Aug 07, 2019 2:39 pm
- Location: San Diego California
-
Return to Sonex-B / Waiex-B
Who is online
Users browsing this forum: No registered users and 3 guests