Taper pin reamer

Use this area for aviation related general discussions, newsworthy items, and non model specific topics.

Re: Taper pin reamer

Postby bvolcko38 » Wed May 20, 2020 1:52 pm

Sent reamer today
Bill Volcko XNS0068
Xenos A N68WV 99% flush rivets
Aerovee and Prince P-Tip
MGL Discovery Lite w/ Sandia STX 165R
V6
First hole 4/1/16
First flight 8/24/18
Phase I complete...finally!!!
Also flying a Challenger II since 1999
User avatar
bvolcko38
 
Posts: 284
Joined: Fri Feb 19, 2016 7:40 am
Location: Finger Lakes

Re: Taper pin reamer

Postby OneTallShort » Sat May 23, 2020 11:32 pm

Just finished with the #1 bs reamer. Worked great for my control sticks with an AN386-2-8A pin. I also used the special washers. Just started with the hole I had for the plans AN4 bolt and reamed it up from there.
Got my hardware from Preferred Airparts. They had NOS parts that looked good and priced right.
Image

Ready to send it on. Need an address.
OneTallShort
 
Posts: 51
Joined: Sat Mar 29, 2014 9:14 am

Previous

Return to General Discussion

Who is online

Users browsing this forum: No registered users and 88 guests