Discussion of Avionics and Flight Instruments. Such as: EFIS, EIS, GPS, COM, NAV, Antennas, Audio Panels, Steam Gauges
by bipbuilder » Wed Mar 25, 2020 10:15 pm
Have the mgl efis lite. It will only show cht temperature at 32 degrees. Egt reads correctly. Have checked rdac ground to engine block is ok. In the settings I assigned tc5-8 to cht k probes.was wondering what I am missing.
-
bipbuilder
-
- Posts: 33
- Joined: Wed Oct 12, 2016 8:18 pm
by DCASonex » Thu Mar 26, 2020 8:16 am
Not familiar with MGL, but most CHT probes are type "J" while most EGT probes are type "K" .
David A.
-
DCASonex
-
- Posts: 935
- Joined: Mon Sep 12, 2011 8:04 pm
- Location: Western NY USA
by Bryan Cotton » Thu Mar 26, 2020 8:42 am
My Brauniger uses all type K.
Bryan Cotton
Poplar Grove, IL C77
Waiex 191 N191YX
Taildragger, Aerovee, acro ailerons
dual sticks with sport trainer controls
Prebuilt spars and machined angle kit
Year 2 flying and approaching 200 hours December 23
-
Bryan Cotton
-
- Posts: 5489
- Joined: Mon Jul 01, 2013 9:54 pm
- Location: C77
-
by bvolcko38 » Thu Mar 26, 2020 9:41 am
I also have a Discovery Lite and it works fine. Its been a while, I can't remember where I bought my sensors but I'm sure its just a setting in your efis.
http://www.mglavionics.com/RDAC_XF_INSTALLATION.pdf
Bill Volcko XNS0068
Xenos A N68WV 99% flush rivets
Aerovee and Prince P-Tip
MGL Discovery Lite w/ Sandia STX 165R
V6
First hole 4/1/16
First flight 8/24/18
Phase I complete...finally!!!
Also flying a Challenger II since 1999
-
bvolcko38
-
- Posts: 284
- Joined: Fri Feb 19, 2016 7:40 am
- Location: Finger Lakes
Return to Avionics and Instruments
Who is online
Users browsing this forum: No registered users and 28 guests