billy's plans built sonex 1735

[Rick524]

Hi Billy, I'll make up a pin to pin diagram for you, but probably will be
tomorrow. The main thing is to get the data lines straight, like encoder lines a1, a2, a3 etc
to the corresponding transponder inputs. Then power and ground. Most other lines
aren't used.
I'll cipher it out in the AM.

Rick

[Rofomoto]

Hi Billy, I'll make up a pin to pin diagram for you, but probably will be
tomorrow. The main thing is to get the data lines straight, like encoder lines a1, a2, a3 etc
to the corresponding transponder inputs. Then power and ground. Most other lines
aren't used.
I'll cipher it out in the AM.

Rick

Can’t thank you enough. Bin looking at this way to long.

[Rick524]

Hi Billy, I sent a diagram of the parallel cable to your email address, I think this will work for you.
With the SS120 and GTX327 you also have the option to use a serial connection between the two.
This may be easier due to only needing 1, RS232 signal line and ground. I'll do another
diagram using the serial connections and send it later today.

Rick

[Rofomoto]

Hi Billy, I sent a diagram of the parallel cable to your email address, I think this will work for you.
With the SS120 and GTX327 you also have the option to use a serial connection between the two.
This may be easier due to only needing 1, RS232 signal line and ground. I'll do another
diagram using the serial connections and send it later today.

Rick

Thanks again Rick

[Rofomoto]

Wow...do these weekly 200.00 orders to aircraft spruce ever end!!! Haha all the small stuff sure adds up. Controls,wiring,ads-b are all things that must be done but every day not much satisfaction like seeing a large part done. All my big parts have bin done for months.

Also, has anyone run wires through spar tunnel at the far outboard lower point on the tunnel? There seems to be a gap there when wings are attached.

[Area 51%]

That's where it calls out on the print (page L-05 view EE and FF) to pass the brake cables through on a trisickle. Our trim cable went through that gap.

[Rick524]

Hi Billy, I ran my coax cable and another bundle of wire under the left side and
a bundle of wire to the ELT and strobe box under the right side. I wrapped them
in spiral wrap for protection.

Rick

[Rofomoto]

Thanx guys. My battery is behind the baggage department so I was thinking of running 4awg through there.

[sonex892.]

Also, has anyone run wires through spar tunnel at the far outboard lower point on the tunnel? There seems to be a gap there when wings are attached.

All my wiring runs under the spars there Billy.
Steve
Sonex 892

[Rofomoto]