Gases passing through pulled rivets

Discussion for builders, pilots, owners, and those interested in building or owning a Onex.

Re: Gases passing through pulled rivets

Postby Onex107 » Fri Sep 13, 2019 10:30 am

I concur. When the vents are closed on the Onex the wind from the tail is blowing around the seat. It is more noticeable in the winter time. When I open the RV vents the draft from the rear is almost gone.
OneX 107
N2107X
Onex107
 
Posts: 506
Joined: Mon Mar 24, 2014 6:44 pm
Location: Peoria, IL

Re: Gases passing through pulled rivets

Postby inventor » Sat Sep 14, 2019 8:40 am

This is great information from a couple of people who have flying aircraft. I will definitely take care of sealing the back end. Thanks.
Onex 150
inventor
 
Posts: 71
Joined: Tue Jun 09, 2015 8:35 am
Location: Oregon

Re: Gases passing through pulled rivets

Postby Bryan Cotton » Sat Sep 14, 2019 10:37 am

Anybody ever figure out a way to seal the ruddervator pushrod exits on a Waiex?
Bryan Cotton
Poplar Grove, IL C77
Waiex 191 N191YX
Taildragger, Aerovee, acro ailerons
dual sticks with sport trainer controls
Prebuilt spars and machined angle kit
Year 2 flying and approaching 200 hours December 23
User avatar
Bryan Cotton
 
Posts: 5496
Joined: Mon Jul 01, 2013 9:54 pm
Location: C77

Re: Gases passing through pulled rivets

Postby N190YX » Sat Sep 14, 2019 1:17 pm

The flat bottom of the fuselage, straight sides and curved top on the Sonex are similar to my Bonanza/Debonair, and the aft fuselage pressurizes in flight, making the cabin hard to head in cold weather due to air flowing into the cabin from the aft fuselage. The Bonanza/Debonair airplanes apparently have long enough tail pipes so the CO does not enter the cabin from this issue. I never have any exhaust residue on the bottom of the fuselage. How far below the fuselage do your tail pipes extend? Just a thought here.
N190YX
 
Posts: 80
Joined: Thu Jun 26, 2014 7:01 pm

Previous

Return to Onex

Who is online

Users browsing this forum: No registered users and 22 guests