Burst oil cooler

Discussion of the Aerovee kit engine.

Burst oil cooler

Postby bvolcko38 » Thu Jun 21, 2018 7:19 pm

First start up today only lasted 10 seconds. My spotter shut me down. Oil cooler sprung a leak. Didn’t even have time to check oil pressure. What could be the cause other than a defective reconditioned oil cooler? Top mount
BV



Sent from my iPhone using Tapatalk
Bill Volcko XNS0068
Xenos A N68WV 99% flush rivets
Aerovee and Prince P-Tip
MGL Discovery Lite w/ Sandia STX 165R
V6
First hole 4/1/16
First flight 8/24/18
Phase I complete...finally!!!
Also flying a Challenger II since 1999
User avatar
bvolcko38
 
Posts: 284
Joined: Fri Feb 19, 2016 7:40 am
Location: Finger Lakes

Re: Burst oil cooler

Postby petep » Thu Jun 21, 2018 10:47 pm

Check the rubber mounting rings between the case and oil cooler closely. Easy place to create a leak. If the cooler truly ruptured and was not defective then check your oil pressure plungers to make sure they are not stuck and not relieving the pressure as they should. Sticking plungers is not an totally uncommon issue.
petep
 
Posts: 81
Joined: Fri Apr 18, 2014 10:02 pm

Burst oil cooler

Postby bvolcko38 » Thu Jun 21, 2018 10:55 pm

Cooler was defective or ruptured. Ring gaskets not leaking. Didn’t have time to check oil pressure


Sent from my iPhone using Tapatalk
Bill Volcko XNS0068
Xenos A N68WV 99% flush rivets
Aerovee and Prince P-Tip
MGL Discovery Lite w/ Sandia STX 165R
V6
First hole 4/1/16
First flight 8/24/18
Phase I complete...finally!!!
Also flying a Challenger II since 1999
User avatar
bvolcko38
 
Posts: 284
Joined: Fri Feb 19, 2016 7:40 am
Location: Finger Lakes

Re: Burst oil cooler

Postby NWade » Fri Jun 22, 2018 1:47 am

Bill -

Search for the thread I started, "Oil Cooler Structural Failure". Lots of info there about a similar issue I had.

--Noel
NWade
 
Posts: 527
Joined: Mon Aug 08, 2011 3:58 pm

Burst oil cooler

Postby bvolcko38 » Fri Jun 22, 2018 7:04 am

Thank you much


Sent from my iPhone using Tapatalk
Bill Volcko XNS0068
Xenos A N68WV 99% flush rivets
Aerovee and Prince P-Tip
MGL Discovery Lite w/ Sandia STX 165R
V6
First hole 4/1/16
First flight 8/24/18
Phase I complete...finally!!!
Also flying a Challenger II since 1999
User avatar
bvolcko38
 
Posts: 284
Joined: Fri Feb 19, 2016 7:40 am
Location: Finger Lakes

Re: Burst oil cooler

Postby bvolcko38 » Mon Jun 25, 2018 10:28 am

Bought a good used genuine vw oil cooler. All good now, except...
my oil pressure won't go above 20 psi.
Aerovee, iEFIS D Lite, VDO oil pressure sender
Also rpm reads 7000 at idle.

Much to work out.

BV
Bill Volcko XNS0068
Xenos A N68WV 99% flush rivets
Aerovee and Prince P-Tip
MGL Discovery Lite w/ Sandia STX 165R
V6
First hole 4/1/16
First flight 8/24/18
Phase I complete...finally!!!
Also flying a Challenger II since 1999
User avatar
bvolcko38
 
Posts: 284
Joined: Fri Feb 19, 2016 7:40 am
Location: Finger Lakes


Return to Aerovee

Who is online

Users browsing this forum: No registered users and 63 guests