vigilant104 wrote:Elsewhere, Mike made a general call for input germane to SBPF, maybe this is something worthwhile (if it hasn't been done already). I'm not the most qualified person to do it, but I'd be happy to put something together over time, if there is interest, if this is new ground, and if folks would be willing to chime in with input. The intent would be twofold:
1) Help folks make it back to the runway when it is entirely practical and safe
2) (Much more important) Minimize delay, indecision, and panic in the case of power failure on takeoff.
A very worthwhile undertaking to say the least! I've had an engine out on take-off in a Challenger 11 LW with a student in the front seat. Engine quit ~100' up. It didn't cross my mind to turn back as I had a good instructor that drilled into my head about not turning back. Still I do think that there are times when it could be considered. Currently on take-off I'm determined to land ahead within about a 30-45º area left to right centered in front of the airplane.
But consider that the crosswind leg after takeoff is done at 5-600' AGL (most airports want 300' below TPA) and the 90º turn is complete. At that point could a turn back be made? We're talking 270º of turns and a downwind landing in a position that may bring you high over the runway depending on how long your departure leg was before the turn (and assuming no obstacles).
There is so much written about this and opinions abound. But if you (with input from the group) can put together some Sonex specific numbers ... I think that would be an awesome piece of information to have. Obviously every pilot will have to set their own minimums and practice this for themselves at altitude but I would give everyone the wise words of my (and many other) instructors ... when the engine stumbles, coughs, sags, or quits, "
GET THAT STICK FORWARD!" Once you have flying speed you can take a breath and aim for that spot you planned to use before take-off if something like this were to happen. You did have a plan didn't you?
Dale Williams
N319WF @ 6J2
Myunn - "daughter of Cleanex"
120 HP - 3.0 Corvair
Tail Wheel - Center Stick
Signature Finish 2200 Paint Job
171.9 hours / Status - Flying
Member # 109 - Florida Sonex Association
Latest video:
https://www.youtube.com/watch?v=1VP7UYEqQ-g