Sonex stick grip PTT

Discussion for builders, pilots, owners, and those interested in building or owning a Onex.

Sonex stick grip PTT

Postby petep » Wed Dec 13, 2017 3:11 pm

Anyone using the Sonex stick grip found a good push to talk switch to fit the grip?
petep
 
Posts: 81
Joined: Fri Apr 18, 2014 10:02 pm

Re: Sonex stick grip PTT

Postby WaiexN143NM » Wed Dec 13, 2017 3:39 pm

Hi pete,
For our legacy waiex, we used the ray allen stick grips. The sonex molded stick grips a good ptt switch from B&c , newton KS. The larger one they sell. Your local electronics store may have some also.

WaiexN143NM
Michael
WaiexN143NM
 
Posts: 1207
Joined: Mon Sep 15, 2014 1:04 am
Location: palm springs CA

Re: Sonex stick grip PTT

Postby jeff0196 » Wed Dec 13, 2017 6:32 pm

Jeffrey W
Waiex 0196
AeroVee Turbo
jeff0196
 
Posts: 44
Joined: Mon Mar 13, 2017 10:16 pm
Location: SE Wisconsin

Re: Sonex stick grip PTT

Postby Onex107 » Thu Dec 14, 2017 2:13 pm

You guys that are looking for stick grips. Go to your nearest bicycle shop and check out the handle bar grips. The one I use is airfoil shaped and has finger notches. No problem drilling for a push to talk.
OneX 107
N2107X
Onex107
 
Posts: 506
Joined: Mon Mar 24, 2014 6:44 pm
Location: Peoria, IL

Re: Sonex stick grip PTT

Postby Spaceman » Sun Sep 30, 2018 12:48 pm

What wire gauge do you guys use to connect the PTT switch? I'm not really getting into electrical stuff yet on my build, but I'm just about ready to install the control stick assembly, so I want to pre-wire it first so I don't have to take it out again later to run wires through it.

Also, I take it you solder the wires to the PTT button and just use a spade connector on the other end then?
Chris Paegelow
N21YX / Waiex-B #21 / Roseville, CA
http://paegelow.blogspot.com/
User avatar
Spaceman
 
Posts: 330
Joined: Sat Jan 21, 2012 5:52 pm
Location: Roseville, CA

Re: Sonex stick grip PTT

Postby mike.smith » Sun Sep 30, 2018 11:48 pm

Spaceman wrote:What wire gauge do you guys use to connect the PTT switch? I'm not really getting into electrical stuff yet on my build, but I'm just about ready to install the control stick assembly, so I want to pre-wire it first so I don't have to take it out again later to run wires through it.

Also, I take it you solder the wires to the PTT button and just use a spade connector on the other end then?


22 ga. It's carrying next to no current; it just closes a loop.
Mike Smith
Sonex N439M
Scratch built, AeroVee, Dual stick, Tail dragger
http://www.mykitlog.com/mikesmith
mike.smith
 
Posts: 1430
Joined: Tue Jan 29, 2013 8:45 pm


Return to Onex

Who is online

Users browsing this forum: No registered users and 16 guests