What rivet size for Turtle deck to fuselage

Discussion for Sonex builders on specific plans page experience. These posts are limited to technical suggestions such as assembly order, challenges, or techniques related to specific plans pages.

What rivet size for Turtle deck to fuselage

Postby lstinthot » Tue Dec 13, 2016 6:06 pm

I believe I need to use CCP-44 rivets to attach the turtle deck to the fuselage, I just can not find in the plans where it calls for them. Page F18 shows to use -42s for the skin to vertical channel.

Can someone point me in the right direction to see where they are called out?

Thanks
Mike
Scratch building #1604
Tail dragger
Thinking Turbo Aerovee
lstinthot
 
Posts: 103
Joined: Fri Aug 03, 2012 12:11 pm

Re: What rivet size for Turtle deck to fuselage

Postby Concorde » Tue Dec 13, 2016 6:28 pm

You are correct. CCP-44. 56 on each side.
Ben
Sonex # 1684
Tri-Gear, Dual Control
Rotax 912uls
N379BS reserved.
Concorde
 
Posts: 176
Joined: Sun Aug 10, 2014 2:11 pm
Location: North Carolina

Re: What rivet size for Turtle deck to fuselage

Postby Concorde » Tue Dec 13, 2016 6:34 pm

53 is the correct number according to the plan.
Ben
Sonex # 1684
Tri-Gear, Dual Control
Rotax 912uls
N379BS reserved.
Concorde
 
Posts: 176
Joined: Sun Aug 10, 2014 2:11 pm
Location: North Carolina

Re: What rivet size for Turtle deck to fuselage

Postby lstinthot » Tue Dec 13, 2016 8:37 pm

Thank you.
Scratch building #1604
Tail dragger
Thinking Turbo Aerovee
lstinthot
 
Posts: 103
Joined: Fri Aug 03, 2012 12:11 pm


Return to Sonex Plans

Who is online

Users browsing this forum: No registered users and 3 guests