by jowens » Sun Sep 11, 2016 11:40 pm
Hi Andrew,
I am in the process of building a Sonex in Rochester, MN. If would like to see a sonex in the building process I would be happy to show you where I am at. My wings are more or less complete and the fuselage is close to the wing rigging stage.
Unfortunately, I cannot help with your question on how a sonex flies but do have some thoughts in general:
-Are you currently a pilot?
-What airplane do you currently fly and does this fulfill your mission to fly between Minneapolis and Chicago?
-If the answer is yes to the previous question- what do you want the sonex to do that is different than your current plane (faster, more quiet, lower expense...)?
-Is a two passenger airplane going to fit more mission long term?
-Depending on equipment and engine the useful load of a sonex may be challenging. The empty weight of the airplane may also help indicate any deviations from the plans the builder did, but more likely it is the bells and whistles they chose to install.
-Sonex pilots come in all shapes and sizes, I believe around 5'8" and small is preferable to fitting in the sonex.
If you are purchasing a completed airplane it is a bit more leg work to get a repairman certificate for the airplane versus being the builder. Experience varies on how difficult this certificate is to attain. If you are willing, doing the Condition Inspection (required annually) saves a lot of money and complexity with finding an A&P willing to work on an experimental airplane.
If you purchase a completed amateur built airplane it is highly recommended to find a builder of the same airplane type that would assist you with a workmanship inspection before even considering purchasing the airplane.
If you are going to the class B airspace of chicago and Minneapolis than the ADB-S mandate will be an important factor and expense to consider.
Jim Owens
Rochester, MN
Jim Owens
Dynon HDX1100, dual controls, Viking 110, taildragger
800 Hours, first flight 10-17-2018