random user submitted photo
Corrosion treatment
13 posts
• Page 2 of 2 • 1, 2
Re: Corrosion treatment
by Darick » Fri Jan 22, 2016 9:42 pm
How about one of the treatments in a spray can like "Corrosion X"? Just mist the insides, keeping it away from the cockpit of course.
Darick Gundy
Sonex #1646
N417DG
Taildragger, Aerovee, center stick, Prince P-Tip Prop
MGL E1, F2, V6 radio, Sandia Xponder, Reserve lift indicator (AOA), iFly 520
First flight! 10/21/2017
Sonex #1646
N417DG
Taildragger, Aerovee, center stick, Prince P-Tip Prop
MGL E1, F2, V6 radio, Sandia Xponder, Reserve lift indicator (AOA), iFly 520
First flight! 10/21/2017
-
Darick - Posts: 496
- Joined: Mon Aug 05, 2013 9:39 pm
- Location: PA
Re: Corrosion treatment
by Bryan Cotton » Fri Jan 22, 2016 9:52 pm
I built an RV4 tail. Acid etch, alodine, epoxy prime everything. Since then I have changed religions. No primer on the Waiex except a few parts I made out of scrap 7075 I had laying around. I am never going back!
Bryan Cotton
Poplar Grove, IL C77
Waiex 191 N191YX
Taildragger, Aerovee, acro ailerons
dual sticks with sport trainer controls
Prebuilt spars and machined angle kit
Year 2 flying and approaching 200 hours December 23
Poplar Grove, IL C77
Waiex 191 N191YX
Taildragger, Aerovee, acro ailerons
dual sticks with sport trainer controls
Prebuilt spars and machined angle kit
Year 2 flying and approaching 200 hours December 23
-
Bryan Cotton - Posts: 5492
- Joined: Mon Jul 01, 2013 9:54 pm
- Location: C77
Re: Corrosion treatment
by WaiexN143NM » Fri Jan 22, 2016 11:52 pm
Hi all,
When building our Waiex, we found the duplicolor self etching primer in olive green color works well. Lite scotch Brite , wipe w acetone, spray . Can be purchased at Kragen/ O'Rielly Auto. Their sand able filling gray primer works good on the fiberglass parts. The primers really stick well , flow out , hard to get a run. Dry fast. Good stuff. Stewart water based epoxy on top on the outside, with Aerographics vynl decal trim.
WaiexN143
Michael Radtke
When building our Waiex, we found the duplicolor self etching primer in olive green color works well. Lite scotch Brite , wipe w acetone, spray . Can be purchased at Kragen/ O'Rielly Auto. Their sand able filling gray primer works good on the fiberglass parts. The primers really stick well , flow out , hard to get a run. Dry fast. Good stuff. Stewart water based epoxy on top on the outside, with Aerographics vynl decal trim.
WaiexN143
Michael Radtke
- WaiexN143NM
- Posts: 1206
- Joined: Mon Sep 15, 2014 1:04 am
- Location: palm springs CA
13 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 20 guests
