random user submitted photo
Jab 3300 Prop Installation
2 posts
• Page 1 of 1
Jab 3300 Prop Installation
by Sonex 772 » Mon Jul 06, 2015 1:44 pm
Hey Guys
I am getting ready to put my Prop on and am a bit confused.. There are 2 sets of holes in the Prop flange, I know I need to use the
4 3/8 holes, but the holes are 5/8" hole and the bolt that is called out in the plans are 3/8". Is there some kind of bushing I need to use to get the hole down to 3/8"?? where can I get the bushings and what are they called??
Thanks
Mike
I am getting ready to put my Prop on and am a bit confused.. There are 2 sets of holes in the Prop flange, I know I need to use the
4 3/8 holes, but the holes are 5/8" hole and the bolt that is called out in the plans are 3/8". Is there some kind of bushing I need to use to get the hole down to 3/8"?? where can I get the bushings and what are they called??
Thanks
Mike
- Sonex 772
- Posts: 46
- Joined: Mon Mar 24, 2014 6:40 pm
Re: Jab 3300 Prop Installation
by sonex892 » Mon Jul 06, 2015 5:58 pm
Mike
You will need to use drive bushings in the larger holes. They are supplied with new engines. Jabiru should sell them.
Steve 892
You will need to use drive bushings in the larger holes. They are supplied with new engines. Jabiru should sell them.
Steve 892
- sonex892
- Posts: 169
- Joined: Fri Jun 03, 2011 4:49 am
- Location: Port Macquarie Australia
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 28 guests
