Onex seat cushion

[Mike53]

Hello Onex builders.
For those that have bought the Onex seat cushion from Sonex can you give me the dimensions .length and thickness of bottom cushion and same for back.
$425 is a bit dear and once I pay the exchange it would work out to over $500 so I will get it made locally.
Thanks,
Mike

[XenosN42]

Hi Mike,

The Sonex supplied OneX seat cushion dimensions are:

Back:
50cm wide x 45 cm high x 4 cm thick

Seat:
50cm wide x 48 cm long (measured from front to back) x 4 cm thick
There is a 10 cm wide x 6 cm long cutout centered in the middle of the seat front for stick clearance.

Have fun building!

Michael
N42XE - XENOS flying 3-1/2 years
N169XE - OneX - less than 6 weeks from first flight!

[Mike53]

Thanks Michael.

[Onex107]

Something you might consider is a wheel chair seat cushion. They are made for long time sitting and run about $40 U.S. They don't have the cutout for the stick but they are about the right size.

[Mike53]

Probably a great idea but I have already purchased my foam .I got this site from this forum but just to put it out there again,here is where I purchased the foam from.
Same stuff as condor but a lot cheaper.Check out the discount section .
http://www.sunmatecushions.com/