Page 1 of 1
Aerovee cylinder baffles
Posted:
Wed Dec 26, 2018 8:53 pmby ProfJ
Hey Folks,
Does anyone know where I can purchase a set of the black steel cylinder baffles seen in this photo? Can't find them on the Aeroconversions site...
Thanks,
Jon
Re: Aerovee cylinder baffles
Posted:
Wed Dec 26, 2018 8:57 pmby ProfJ
OK, found them at Aircooled.
Re: Aerovee cylinder baffles
Posted:
Thu Dec 27, 2018 12:58 amby lutorm
Those are mounted up side down, they go on the bottom of the cylinders.
Re: Aerovee cylinder baffles
Posted:
Thu Dec 27, 2018 7:58 amby Stogie6
Super tins...yep, on the bottom just above the push rod tubes! Snap right on.
Re: Aerovee cylinder baffles
Posted:
Thu Dec 27, 2018 12:44 pmby ProfJ
lutorm wrote:Those are mounted up side down, they go on the bottom of the cylinders.
If you were setting up for updraft cooling rather than downdraft (in a pusher setup) would you switch the tins top to bottom, or keep them on the original sides? (assuming you had the original top tins also.) Seems to me that their shape will be optimized for airflow direction?
Re: Aerovee cylinder baffles
Posted:
Thu Dec 27, 2018 12:57 pmby lutorm
Yeah i guess if you have updraft, you'd want something on the top. But I don't know if they'll fit, the cylinders are symmetric, but the heads aren't symmetric top vs bottom.