SonexBuilders.net

A Forum for Sonex Aircraft Builders and Enthusiasts

Skip to content

LogoLogoLogo
random user submitted photo

trigger shaft assembly

Discussion of the Aerovee kit engine.
Post a reply

trigger shaft assembly

Postby Sonex1414 » Mon Jun 02, 2014 9:05 pm

I took the stator off and two of the ACV-Z01-36 cap screws that hold in the trigger shaft assembly were loose. One of them fell out. The stator had been rubbing on the screws. Obviously I can not put in a new 1/4 X 28 cap screw. I am going to have to up drill the hole and retap it. Has anyone done this and what did you use and how did it work out?
Sonex1414
 
Posts: 21
Joined: Mon Jun 02, 2014 8:53 pm
Top

Re: trigger shaft assembly

Postby oynif » Tue Jun 03, 2014 12:23 pm

Excactly why not put in a new screw, is thread Damaged ?
Kurt
oynif
 
Posts: 16
Joined: Wed Mar 26, 2014 4:34 am
Top

Post a reply

Return to Aerovee

Who is online

Users browsing this forum: No registered users and 21 guests

Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group

SonexBuilders.net is NOT affiliated with Sonex Aircraft LLC. Discussion contents reflect the views of individual participants only. The owner of SonexBuilders.net makes no guarantees about the correctness or the accuracy of ANY of the information on or in any area or page of SonexBuilders.net. Verify ALL information obtained from SonexBuilders.net with the kit designer, equipment manufacturer, or other original official source before using that information. By participating in this website in any form, (including but not limited to reading, viewing, posting, and private messaging) you agree not to hold the owner (AVED LLC), owner members, forum members, or advertisers of SonexBuilders.net legally liable for information found on any of the pages of the website.

SonexBuilders.net is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.