SonexBuilders.net

Where the counterbalance plates exit the front of the aileron there is a series of rivets required along the sides of the plates and then there are 4 rivets that go thru the hinge, the skin and into the counterbalance ribs. I'm curious how builders have been setting these rivets, especially the 4 mentioned since the plates are blocking access...meaning I cant get the rivet gun or any of my hand rivet pullers anywhere near the right position to pull the rivet because the plates are in the way.

The rivets along the side of the plates wont be easy but they are do-able...its the 4 thru the hinge that have me stuck. I used a 12" bit to drill those holes so that the drill would be clear of the plates.

any advice would be appreciated.

thanks

peter
SNB0021

Can you post a picture ?

Check out this tool thread:
viewtopic.php?f=34&t=2345

It has this link:
viewtopic.php?f=43&t=2300&start=10

Bryan Cotton wrote:Check out this tool thread:
viewtopic.php?f=34&t=2345

It has this link:
viewtopic.php?f=43&t=2300&start=10

That's exactly what I was talking about. Thanks. I had updrilled all the parts and disassembled only to discover that I drilled those two inside holes too close to the plates ruining the support bracket on the other side of the skin. Not sure how to recover from this thinking I should have stuck with triathlon....prob need to order more parts and. start the aileron over
Thanks...
Peter

That little PRG 410 rivet puller is the most useful thing I've bought! I found one on ebay for like $8 and it has been a lifesaver. I don't even know how you could build this plane without one.

https://www.ebay.com/sch/i.html?_from=R ... 0&_sacat=0