Sonex stick grip PTT
Posted:
Wed Dec 13, 2017 3:11 pmby petep
Anyone using the Sonex stick grip found a good push to talk switch to fit the grip?
Re: Sonex stick grip PTT
Posted:
Wed Dec 13, 2017 3:39 pmby WaiexN143NM
Hi pete,
For our legacy waiex, we used the ray allen stick grips. The sonex molded stick grips a good ptt switch from B&c , newton KS. The larger one they sell. Your local electronics store may have some also.
WaiexN143NM
Michael
Re: Sonex stick grip PTT
Posted:
Wed Dec 13, 2017 6:32 pmby jeff0196
Re: Sonex stick grip PTT
Posted:
Thu Dec 14, 2017 2:13 pmby Onex107
You guys that are looking for stick grips. Go to your nearest bicycle shop and check out the handle bar grips. The one I use is airfoil shaped and has finger notches. No problem drilling for a push to talk.
Re: Sonex stick grip PTT
Posted:
Sun Sep 30, 2018 12:48 pmby Spaceman
What wire gauge do you guys use to connect the PTT switch? I'm not really getting into electrical stuff yet on my build, but I'm just about ready to install the control stick assembly, so I want to pre-wire it first so I don't have to take it out again later to run wires through it.
Also, I take it you solder the wires to the PTT button and just use a spade connector on the other end then?
Re: Sonex stick grip PTT
Posted:
Sun Sep 30, 2018 11:48 pmby mike.smith
Spaceman wrote:What wire gauge do you guys use to connect the PTT switch? I'm not really getting into electrical stuff yet on my build, but I'm just about ready to install the control stick assembly, so I want to pre-wire it first so I don't have to take it out again later to run wires through it.
Also, I take it you solder the wires to the PTT button and just use a spade connector on the other end then?
22 ga. It's carrying next to no current; it just closes a loop.