Page 1 of 1
Onex Fuel Line
Posted:
Fri Aug 07, 2015 9:09 pmby paulonex
All
The Onex plans call for an aluminum tube fuel line from the tank to the firewall.
My question is there a good reason for this.
It seems to me a "rubber" fuel rated line would be safer.
No risk of cracking from vibration and if in a crash would not likely kink and leak.
I assume Sonex / industry has a reason, does anybody know why Aluminum?
Thanks in advance for the insight / understanding.
Paul
Re: Onex Fuel Line
Posted:
Fri Aug 07, 2015 9:39 pmby SonexN76ET
Paul, that is a great question and I look forward to the answers. I know a great many of us do use flexible fuel line in the cockpit. I am using Russell hose with AN fittings in my Sonex.
The only downside I can see to the flexible hose with AN fittings is you are supposed to replace the hose every so many years per the hose manufacturer.
Jake
Re: Onex Fuel Line
Posted:
Fri Aug 07, 2015 11:56 pmby wlarson861
Not sure about the Onex but the sonex fuel line routing would require several support points to keep it from sagging. The hard line is self supporting, is easier to install and cheaper. My fuel line goes straight from the tank through the firewall, then into a filter and then braided hose to the aerocarb.
Re: Onex Fuel Line
Posted:
Sat Aug 08, 2015 12:50 pmby onex28
From the fuel cut off valve to the 45degree fitting through the firewall to the gascolator I have 12 inches of braided hose with AN6 fittings. For me personally it was more practical than trying to get this old guy to crawl under the tank to install AL tubing. I was able to attach one end to the gascolator fitting, install the tank, and attach the other end to the shut off valve while sitting in the seat. No sag in the line.
Onex 28
N951X (reserved)