Page 1 of 1
rudder pedal fit into blocks
Posted:
Fri Jul 03, 2015 9:11 pmby surfly
After removing the powder coat on the ends of the rudder pedal shafts and applying bearing grease both to the shaft ends and inside the blocks the shafts are still way too tight to turn inside the blocks. Suggestions anyone???????
Surfly
Re: rudder pedal fit into blocks
Posted:
Fri Jul 03, 2015 10:22 pmby saddler
Wasn't my idea, but I used a brake hone and it worked great. Takes a little time but does the trick. Also make sure you have clearanced the blocks for the welds on the pedals.
http://www.autozone.com/test-scan-and-s ... 47928_0_0/
Re: rudder pedal fit into blocks
Posted:
Sat Jul 04, 2015 2:15 amby Brett
rudder pedal fit into blocks
Posted:
Sat Jul 04, 2015 8:37 amby Sonex1517
While mine was on a Sonex, I had to really work to clearance for the tube welds. It hung up and bound the rotation.
Robbie Culver
Sonex 1517
Chicagoland
Tails and Wings complete - finishing fuselage.
N1517S reserved
Re: rudder pedal fit into blocks
Posted:
Sat Jul 04, 2015 9:28 amby Rynoth
I used the brake hone method also. It's just trial and error, you want things secure but not in a bind. You could also add some paper spacers between the phenolic halves open up the holes slightly.
Re: rudder pedal fit into blocks
Posted:
Sat Jul 04, 2015 9:31 amby andrewp
Like everyone else (I am such a follower), I just opened it up. I would like to say that I used a brake hone, but I used some files and sand paper... trial and error!
AP
#618
Re: rudder pedal fit into blocks
Posted:
Sun Jul 05, 2015 2:47 amby nwyooper
You also need to make sure there is clearance between the bottom of the rudder pedal tube and the center angle on the cockpit floor. Mine worked fine until I tightened the blocks down and then they bound up because the tube rubbed on the angle. Cut a little relief in the angle and works fine. Also drilled a little hole it the top of blocks so a drop or two of oil could be added from time to time.
Re: rudder pedal fit into blocks
Posted:
Sun Jul 05, 2015 8:01 amby Brett
nwyooper wrote:Also drilled a little hole it the top of blocks so a drop or two of oil could be added from time to time.
Wish I had of thought of that. Great idea but a bit late now for me.
Re: rudder pedal fit into blocks
Posted:
Sun Jul 05, 2015 12:13 pmby surfly
Brett your lubrication hole is a GREAT idea. I will be doing the same. Sometimes the simplest ideas guarantee the greatest rewards. Surfly
Re: rudder pedal fit into blocks
Posted:
Sun Jul 05, 2015 1:11 pmby Bryan Cotton
I holesawed my flap and pedal blocks. The 1" holesaw gave a pretty nice fit and I didn't need to open up the holes. I used white lithium grease on assembly. I did a fit check of the holesaw using scrap oak first.