Page 1 of 1
Onex seat cushion
Posted:
Sat Mar 21, 2015 6:39 pmby Mike53
Hello Onex builders.
For those that have bought the Onex seat cushion from Sonex can you give me the dimensions .length and thickness of bottom cushion and same for back.
$425 is a bit dear and once I pay the exchange it would work out to over $500 so I will get it made locally.
Thanks,
Mike
Re: Onex seat cushion
Posted:
Sun Mar 22, 2015 10:33 amby XenosN42
Hi Mike,
The Sonex supplied OneX seat cushion dimensions are:
Back:
50cm wide x 45 cm high x 4 cm thick
Seat:
50cm wide x 48 cm long (measured from front to back) x 4 cm thick
There is a 10 cm wide x 6 cm long cutout centered in the middle of the seat front for stick clearance.
Have fun building!
Michael
N42XE - XENOS flying 3-1/2 years
N169XE - OneX - less than 6 weeks from first flight!
Re: Onex seat cushion
Posted:
Sun Mar 22, 2015 4:32 pmby Mike53
Thanks Michael.
Re: Onex seat cushion
Posted:
Mon Apr 06, 2015 9:53 amby Onex107
Something you might consider is a wheel chair seat cushion. They are made for long time sitting and run about $40 U.S. They don't have the cutout for the stick but they are about the right size.
Re: Onex seat cushion
Posted:
Mon Apr 06, 2015 5:34 pmby Mike53
Probably a great idea but I have already purchased my foam .I got this site from this forum but just to put it out there again,here is where I purchased the foam from.
Same stuff as condor but a lot cheaper.Check out the discount section .
http://www.sunmatecushions.com/