Page 1 of 1
Onex Rudder cable routing
Posted:
Sun Jun 01, 2014 9:58 pmby thomasjones42
Has anybody had a problem with the routing of the right side rudder cable. As I ran mine today I find it sharing a frame hole with the elevator control rod and doing sort of a half wrap on the elevator control rod enroute to the final frame hole behind the seat. Not certain if I have missed something in the plans or what.
Re: Onex Rudder cable routing
Posted:
Sun Jun 01, 2014 10:30 pmby onex28
There have been revisions on the relocation of some of the routing holes. I simply put the holes and added a pulley so I had a run clear of the elevator control rod. I moved the first pulley to the outside of the first former and added a pulley in the vertical position to the next former. Pics on my PC that doesn't send. PM me if you want pics and I'll take some for you.
David
Re: Onex Rudder cable routing
Posted:
Tue Jun 03, 2014 4:43 pmby onex0127
I attached the elevator push pull tube on the inboard side, this gave me plenty of room for the rudder cable outboard.
- Right side rudder cable
- 2013-09-23_13-37-54_953.jpg (384.23 KiB) Viewed 2569 times
Re: Onex Rudder cable routing
Posted:
Tue Jun 03, 2014 4:48 pmby onex0127
This is on with the elevator trim. It works
Re: Onex Rudder cable routing
Posted:
Tue Jun 03, 2014 4:52 pmby onex0127
I hope this helps