SNX-F21: Tail attachment questions

Discussion for Sonex builders on specific plans page experience. These posts are limited to technical suggestions such as assembly order, challenges, or techniques related to specific plans pages.

SNX-F21: Tail attachment questions

Postby SP1 » Thu Apr 30, 2020 12:46 pm

Hi All,
I'm at this page and had a few questions.

I'm trying to understand aligning SNX-F23-01 for drilling. What landmarks did you use? Since the skid mount doesn't have any alignment holes, I can imagine a scenario where you had drilled the skid mount and its front flange doesn't match F23-03 well.

F23-04- lower mount angle. how do you align this? Is the general thought to remove lower vertical fin post assembly from the tail, and use that to align the lower mount angle?

Appreciate any thoughts you have.
SP1
 
Posts: 120
Joined: Sat Sep 10, 2016 2:04 am

Return to Sonex Plans

Who is online

Users browsing this forum: No registered users and 17 guests