SNX-F10-06 hook mount
Posted:
Fri Aug 03, 2018 12:19 pmby Rofomoto
I don’t need this if using Bowden cable trim correct? Thanx billy
Re: SNX-F10-06 hook mount
Posted:
Sun Aug 05, 2018 8:02 amby peter anson
Not Correct. The elevator isn't mass balanced so even if you are using the cable operated trim tab, you need some sort of spring balance for the elevator. SNX-C01 mentions a bungee to support the elevator level or slightly down and warns you not to cut it too short. I used a small pulley on one end and a bungee from the other end going around the pulley and going back to an adjustable cleat, a small yacht fitting, so that the bungee is easily adjustable.
Peter
Re: SNX-F10-06 hook mount
Posted:
Sun Aug 05, 2018 10:01 amby Rofomoto
peter anson wrote:Not Correct. The elevator isn't mass balanced so even if you are using the cable operated trim tab, you need some sort of spring balance for the elevator. SNX-C01 mentions a bungee to support the elevator level or slightly down and warns you not to cut it too short. I used a small pulley on one end and a bungee from the other end going around the pulley and going back to an adjustable cleat, a small yacht fitting, so that the bungee is easily adjustable.
Peter
Thanx Peter.. should have looked farther down the line. Thanx again