Page 1 of 1

NACA duct locations?

PostPosted: Wed Jan 18, 2017 7:31 pm
by kevinh
HI ya'll,

So I have Peter's nice NACA vents. And I could swear I remember a place in the plans where Sonex shows where to cut the vent locations. Alas, I must now be blind because I can't find the right sheet. Anyone remember where it is?

Kevin

Re: NACA duct locations?

PostPosted: Wed Jan 18, 2017 7:59 pm
by rizzz
kevinh wrote:HI ya'll,

So I have Peter's nice NACA vents. And I could swear I remember a place in the plans where Sonex shows where to cut the vent locations. Alas, I must now be blind because I can't find the right sheet. Anyone remember where it is?

Kevin


Hi Kevin,
What plans number do you have?
This is only a guess but I have a suspicion Sonex might have removed the original vents from the plans as nearly everyone now implements their own preferred solution for this.
Most use the standard VANS vents which are placed forward of the original location, others use the half turn bowls that go in the windshield (I think Sonex themselves do that one), some use the new RV12 vents, many now go for Peter Anson's super cool solution or similar...
Anyway, if I don't forget I'll see if I can find the original location in my old plans (145) when I get home tonight.

Re: NACA duct locations?

PostPosted: Wed Jan 18, 2017 10:14 pm
by tonyr
Kevin,

No dimensions as such, but as high and as far forward as you can get them without interfering with any surrounding angles, tank etc.

(In the section just behind the vertical channel that supports the rudder block brackets)

Cheers
Tony

Re: NACA duct locations?

PostPosted: Wed Jan 18, 2017 10:23 pm
by rizzz
tonyr wrote:Kevin,

No dimensions as such, but as high and as far forward as you can get them without interfering with any surrounding angles, tank etc.

(In the section just behind the vertical channel that supports the rudder block brackets)

Cheers
Tony


You're talking about the VANS ducted naca vents right? those indeed go as far forward as possible
The standard Sonex vents were located further aft, this is also the location Peter (Anson's) vents are located.

Re: NACA duct locations?

PostPosted: Wed Jan 18, 2017 10:30 pm
by Sonex1243
Hi Kevin;
Plans sheet SNX-F13 shows the cutout detail for mine. Not sure if it would be the same sheet for your WX though.

Re: NACA duct locations?

PostPosted: Wed Jan 18, 2017 10:40 pm
by rizzz
Sonex1243 wrote:Hi Kevin;
Plans sheet SNX-F13 shows the cutout detail for mine. Not sure if it would be the same sheet for your WX though.


Correct, I found a scan of that drawing on my PC, I almost posted it here but then remembered that might get me in trouble.
Kevin, Send me a PM if you find your plans do not detail the location of the vents.

Re: NACA duct locations?

PostPosted: Thu Jan 19, 2017 2:54 am
by Corby202
Kevin I would suggest the main consideration for the NACA duct vent positioning would be the clearance to the brake/flap handles, so the higher the better.

Phil

Re: NACA duct locations?

PostPosted: Thu Jan 19, 2017 2:54 am
by Corby202
Kevin I would suggest the main consideration for the NACA duct vent positioning would be the clearance to the brake/flap handles, so the higher the better.

Phil