SNX-C02
Posted:
Wed Jun 01, 2016 2:05 pmby Bryan Cotton
I think that is the right page reference. Anyway, the four 5/8" ID 3/4" OD bronze bushings are supposed to press into the weldment that holds the sticks. Mine drop in. How can I line bore them if they spin in the tube? Should I bond them in? Duct tape?
Re: SNX-C02
Posted:
Wed Jun 01, 2016 6:20 pmby GordonTurner
Bryan,
It's no 150....you're supposed to use gorilla tape.
Gordon
Re: SNX-C02
Posted:
Wed Jun 01, 2016 6:54 pmby MichaelFarley56
It's been a few years Bryan but I'm fairly certain I just glued mine in place with epoxy. They've never moved since I installed them!
Re: SNX-C02
Posted:
Wed Jun 01, 2016 11:03 pmby rizzz
Looking back at my log, it appears I had the same problem, used JB Weld:
http://www.mykitlog.com/users/display_l ... 286&row=74