Reducing the confusion

[BobDz]

Since I am waiting for backorders, I've been skipping ahead trying to complete some sub-assemblies. Today was F16-03 Aft Tunnel Web Assembly.

I've started redlining my drawings to eliminate some of the confusion. Attached is an example, one that I suggest builders new to the plans use, and the way I was taught to properly prepare drawings many decades ago...

[flyguy0609]

Your plans look different than mine. On my plans the Qty required and where used is found in the lower left hand corner. The exception is when a part is used for an assembly occurring on the same sheet. I would like to see the use of a single datum for measurement. Dimensions on a drawing and not just "full scale drawing".
Oh well, I may be going to hell in a bucket, but at least I'm enjoying the ride.