SonexBuilders.net

Posted: **Mon Jan 05, 2015 7:27 pm**

I removed my prop from Aerovee engine to change my prop for the Turbo I am installing. Problem is I cannot seem to separate the prop spinner from the prop. I have tapped and tapped to no avail!! Any thoughts or advice would be most welcome and appreciated. I COULD buy a new spinner but I'd rather not.
Jack L
N369UR

Posted: **Tue Jan 06, 2015 7:14 am**

Jack

If all else failed. I would probably try heating the spinner with a hot air gun then tap the spinner with a rubber mallet?

Steve
Sonex 892

SonexBuilders.net

Separate Prop Crush plate/Spinner from Prop?

Separate Prop Crush plate/Spinner from Prop?

Re: Separate Prop Crush plate/Spinner from Prop?