Brand New Prince Prop De-Laminating.. Issue Resolved

[142YX]

I sent mine back on Monday too. I expect to get my new one in a week or two.

I had painted the crush plate/nose cone but it chipped when I torqued the bolts. So I stripped all the paint off it. WIll leave it naked.

What did you use to paint your spinner that did not give you good results? I was hoping to paint mine..

[fastj22]

The same auto paint I used for the rest of the plane. The only problem areas were under the bolt heads. As I tightened the bolts, the paint gave way under them leaving unsightly chips. If I did it again, I'd mask off the surfaces.