SonexBuilders.net

I have the basic C frame bench top rivet/dimpling tool. I'm considering converting it to air operated with a foot control. This would leave both hands free to manipulate the material. A basic pneumatic actuator is fairly cheap.

Just wondering if anyone has attempted to do this.

Yes, I know, I have way too much free time and think way too much about such shenanigans.

BobDz wrote:Yes, I know, I have way too much free time and think way too much about such shenanigans.

This too shall pass.

Area 51% wrote:

BobDz wrote:.

This too shall pass.

Most likely will coincide with the pickup of my fuselage kit!

Area 51% wrote:
This too shall pass.

Most likely will coincide with the pickup of my fuselage kit!