Page 1 of 4
Tool loan program
Posted:
Sun Nov 27, 2016 8:27 pmby Bryan Cotton
All,
There is a thread of the same topic name for the Sonex foundation but I can't post there.
viewtopic.php?f=40&t=2516&p=18856I have the tapered reamer for the mixer and am happy to send it on to the next person. Also, my wing rigging bushings (.3725" OD 1/4" ID) are available.
Re: Tool loan program
Posted:
Sat Dec 03, 2016 12:01 pmby kevinh
Hey Bryan,
In about 9mos-1yr I'll happily take you up on your offer of the bushings loan :D .
Kevin
Re: Tool loan program
Posted:
Fri Apr 21, 2017 8:59 amby bvolcko38
I am ready to ream mixer for taper pin and would like to borrow taper pin reamer, if that is still available.
Re: Tool loan program
Posted:
Fri Apr 21, 2017 11:37 amby Bryan Cotton
Bill,
I'll look for it at the hangar tonight. PM me your address and I'll send it your way.
Re: Tool loan program
Posted:
Sun Apr 23, 2017 8:34 pmby kevinh
If not, I have one I can loan. Though I'm out of the country right now and can't loan it till June 1.
Re: Tool loan program
Posted:
Sun Apr 23, 2017 9:34 pmby Bryan Cotton
I've got it boxed and would have had it in the mail today, but the self service machine at the USPO died. I'll get it in the mail tomorrow.
Re: Tool loan program
Posted:
Mon Apr 24, 2017 8:10 amby bvolcko38
Thank you Bryan. When the next builder needs it, you'll know where it is.
Re: Tool loan program
Posted:
Sun Apr 30, 2017 10:34 amby bvolcko38
Mixer is reamed and taper pin installed. Ready to send taper pin reamer to the next user.
BV
Re: Tool loan program
Posted:
Sat Nov 04, 2017 10:43 amby kevinh
Do Bryan was kind enough to loan me the bushings he made for wing rigging. They worked great. I'm happy to forward them to the next person who needs them (and happy to take them back if that person doesn't want to handle loaning to the _next_ person). Send me a PM and I'll hook you up. ;-)
Re: Tool loan program
Posted:
Sat Nov 04, 2017 11:07 pmby Sonex1517
kevinh wrote:Do Bryan was kind enough to loan me the bushings he made for wing rigging. They worked great. I'm happy to forward them to the next person who needs them (and happy to take them back if that person doesn't want to handle loaning to the _next_ person). Send me a PM and I'll hook you up. ;-)
Just as a reminder to everyone, we have an informal tool loan program via the Sonex Builders and Pilots Foundation, in addition to this ongoing post.
Check out
http://www.sonexfoundation.com/Tool_Loan_Program.phpNot sure who has the taper reamer right now. I used it on my controls and am very happy with the results.
Always good to see folks helping one another.