Page 1 of 1
Question for Canadian Builders
Posted:
Sun May 20, 2018 11:22 amby Rick524
Where did you mount your data plate? Cars say to rear of passenger entrance.
Would under the horizontal stab pass?
Thanks.
Rick
Sonex 524
Re: Question for Canadian Builders
Posted:
Mon May 21, 2018 3:12 amby Friesen5
I mounted mine under the horizontal stab, on the left pilot side. Mine was completed in 2007 and no issues back then.
Mervin Friesen
C-FMNX
Sonex 122
Re: Question for Canadian Builders
Posted:
Mon May 21, 2018 9:54 amby Rick524
Thanks Mervin. That's where most planes I've seen have them. The regs
can be interpreted different ways. I'll go with that.
Rick
C-GRIX
Sonex 524
Re: Question for Canadian Builders
Posted:
Mon May 21, 2018 10:35 amby Gordon
Data Plate Location
I mounted mine even with the leading edge of the horizontal stab and about 5" below on the pilots side of the fuse skin. That is the same spot I used on my previous RV's and it was accepted by the MD-RA.
Gordon......Onex C-IODB...Hummel 2400
Re: Question for Canadian Builders
Posted:
Sat May 26, 2018 9:21 amby Sonex1384
I'm a little late to chime in but mine is the same. Below leading edge of left stab leading edge.