MGL EGT SENDER
Posted: Sun Dec 13, 2020 10:28 amI do not have the MGL EGT senders yet was wondering if anyone could confirm the probe hole drill size. From what I have seen it might be 1/4". I emailed the MGL rep ...no response.
Peter
Peter
SonexBuilders.net
A Forum for Sonex Aircraft Builders and Enthusiasts
https://sonexbuilders.net/
MGL EGT SENDER
Page 1 of 1
Posted: Sun Dec 13, 2020 10:28 amRe: MGL EGT SENDER
Posted: Sun Dec 13, 2020 10:42 amMichigan Avionics took over support for MGL some months ago. Did you e-mail Adam there?
Re: MGL EGT SENDER
Posted: Sun Dec 13, 2020 11:47 ampilotyoung wrote:Michigan Avionics took over support for MGL some months ago. Did you e-mail Adam there?
I emailed the main contact address at Michigan not him specifically.
Re: MGL EGT SENDER
Posted: Tue Dec 15, 2020 3:33 pmI have the MGL EGT thermocouples in my Aerovee engine. I purchased them from Aircraft Spruce (11-07842). The probes are 5mm but the holes in the exhaust pipes are 13/64". Hope this helps.
Steve
Steve
Re: MGL EGT SENDER
Posted: Tue Dec 15, 2020 4:17 pmStevetin wrote:I have the MGL EGT thermocouples in my Aerovee engine. I purchased them from Aircraft Spruce (11-07842). The probes are 5mm but the holes in the exhaust pipes are 13/64". Hope this helps.
Steve
Perfect...
Thanks
Peter