Mgl cht settings
Posted:
Wed Mar 25, 2020 10:15 pmby bipbuilder
Have the mgl efis lite. It will only show cht temperature at 32 degrees. Egt reads correctly. Have checked rdac ground to engine block is ok. In the settings I assigned tc5-8 to cht k probes.was wondering what I am missing.
Re: Mgl cht settings
Posted:
Thu Mar 26, 2020 8:16 amby DCASonex
Not familiar with MGL, but most CHT probes are type "J" while most EGT probes are type "K" .
David A.
Re: Mgl cht settings
Posted:
Thu Mar 26, 2020 8:42 amby Bryan Cotton
My Brauniger uses all type K.
Re: Mgl cht settings
Posted:
Thu Mar 26, 2020 9:41 amby bvolcko38
I also have a Discovery Lite and it works fine. Its been a while, I can't remember where I bought my sensors but I'm sure its just a setting in your efis.
http://www.mglavionics.com/RDAC_XF_INSTALLATION.pdf