Enigma/IOX/shunt calibration
Posted: Tue Dec 11, 2012 7:24 pmAnyone have any experience / tips on calibrating an Enigma shunt?
Thanks!
Rick
Sonex524
Thanks!
Rick
Sonex524
SonexBuilders.net
A Forum for Sonex Aircraft Builders and Enthusiasts
https://sonexbuilders.net/
Enigma/IOX/shunt calibration
Page 1 of 1
Posted: Tue Dec 11, 2012 7:24 pmRe: Enigma/IOX/shunt calibration
Posted: Thu Jun 13, 2013 6:25 amIf you want to know anything about these then you should visit 3d prototyping as I also gain many information from these related to Enigma/IOX/shunt calibration.
Re: Enigma/IOX/shunt calibration
Posted: Thu Jun 13, 2013 7:26 amRick524 wrote:Anyone have any experience / tips on calibrating an Enigma shunt?
Thanks!
Rick
Sonex524
Hi Rick.
Have you tried the MGL forum.There will likely be more knowledge base over there. http://www.mglavionicsusers.org/
Cheers,
Mike
Re: Enigma/IOX/shunt calibration
Posted: Fri Jun 14, 2013 4:20 pmHi Mike, I've searched the MGL board and see others have had similar problems. Bob Meyers was
a big help to me. He didn't have any problems with his setup, so I know it can be done. I saw a post
somewhere that its a software problem. You get one shot at the setup and if you mess up it wont
calibrate again. There is a sequence of keystrokes and resets to go thru to get it calibrated....I saved the
message somewhere. I moved on to other things and will try again when I'm ready.
Rick
Sonex 524
a big help to me. He didn't have any problems with his setup, so I know it can be done. I saw a post
somewhere that its a software problem. You get one shot at the setup and if you mess up it wont
calibrate again. There is a sequence of keystrokes and resets to go thru to get it calibrated....I saved the
message somewhere. I moved on to other things and will try again when I'm ready.
Rick
Sonex 524