Page 1 of 1
replacing flywheel bolts 3300
Posted:
Tue Jan 13, 2015 8:31 pmby kevin814
Hi,
I was wondering if any here have replaced their flywheel bolts on a Jab 3300. I will be replacing mine soon, and was hoping to be able to do it without removing the engine. :?
Anyone do it with the engine still installed? any Gotcha's or things to look out for?
Thanks,
Kevin K.
Re: replacing flywheel bolts 3300
Posted:
Wed Jan 14, 2015 12:01 amby daleandee
Hi Kevin,
There has been an intensive conversation on the Jabiru Yahoo group lately about flywheel bolts:
https://groups.yahoo.com/neo/groups/jab ... s/messagesDunno if this helps ...
Dale
N319WF
Re: replacing flywheel bolts 3300
Posted:
Sat Jan 24, 2015 6:11 amby peter anson
I replaced mine a couple of years ago. The only way to get access is to remove the engine. I left the engine hanging from an engine hoist so I didn't have to disconnect all the thermocouples, just the carburettor connections and a few electrical connections. Like many of those jobs, it wasn't too bad but the hoist was essential.
Peter
Sonex 894
Re: replacing flywheel bolts 3300
Posted:
Sun Jan 25, 2015 10:49 amby mgranger
Peter - Why did you have to remove the engine ? I replaced mine with no problem with the engine in place. I only had to remove the alternator plate from the rear, and the bolts were easily accessible.
Mike
Sonex 611
Jab 3300 s/n 823