Page 1 of 1
Mounting GoPro
Posted:
Thu Dec 25, 2014 11:59 pmby mike.smith
My wife was kind enough to get me a GoPro for Christmas. :-) For those of you who have mounted one on the exterior of your Sonex, are the stock adhesive mounts adequate? I see it's the 3M VHB adhesive, which is tenacious if left to cure for 24 hours. I do loops and rolls and such, so there are some G's involved.
Thanks,
Re: Mounting GoPro
Posted:
Fri Dec 26, 2014 8:37 amby onex28
Hi Mike, the 3M will hold the camera. Mine is still on and if I Want to relocate it I'm going to have to research on how to get the adhesive to release.
David
ONEX 28
Re: Mounting GoPro
Posted:
Fri Dec 26, 2014 9:53 amby fastj22
I read you have apply heat to get them to release. Otherwise they are rather permanent.
I was trying to remove one from inside the cockpit and became worried it would pull the paint off before the tape came. I'll try heat next time.
Re: Mounting GoPro
Posted:
Fri Dec 26, 2014 10:49 amby gammaxy
Can you tie a knot in a piece of fishing line and use it to saw back and forth through the foam?