Myunn - the Daughter of Cleanex

[lucio]

Hi Mark
Thank you for you comments
With the due respect, we cannot apply the WTO rules according to our conveniences (if this the right word). I dont think anybody wil be hurt if a few plans are sold here
Concerning the extra expences for support it would be more or less like US, i.e. usually are the builders that call and pay for the phone calls. Furthermore, I mentioned that here we have already all the parts available ( I mentioned the spars that look like impossible to make according to Sonex) and composite parts as well. Better sell plans than nothing. There is also the childish rule that when something is forbidden then we like it.The ethical values nowaday are lower than ever, so copies are available though I would never buy one of those.
The engine issue is that here in Europe the engine mounts for Rotax are available, or just the drawing to make our own engine mount. Those flying with Rotax fly great, see on "youtube"
Thank you again for your comments
Lucio

[daleandee]

*

[dcstrng]

I like your panel -- super! I'm a few years away from needing them, but I've got both those MGL Instruments on my wish-list as well as the LRI... looks great to my mind...

Is that the iFly also?

-- Larry

[daleandee]

*

[daleandee]

*

[Onex77]

Nice, very nice Dale looking good. :D

[phenry]

Dale,
I note on the Kitplanes page you mention:
"the 20 lbs of paint was added with Signature Finish products (http://www.signaturefinish.com) using Tom Fabula’s roll on application method."
I have been trying to find out more about this roll on process, could you please tell me some more?

[daleandee]

*