random user submitted photo
AeroVee 2.1 For Sale
4 posts
• Page 1 of 1
AeroVee 2.1 For Sale
by Wanttobuild25 » Tue Jan 28, 2025 1:08 pm
This engine was on a Onex that had an Airworthiness Cert but was never flown by the builder. I ran the engine a few times before removing it. I chose to install a different engine with more HP.
Engine has ground run/taxi test time only.
Includes baffling, exhaust, Onex engine mount.
$6800 for all.
Engine has ground run/taxi test time only.
Includes baffling, exhaust, Onex engine mount.
$6800 for all.
- Attachments
-
-
-
- Wanttobuild25
- Posts: 12
- Joined: Wed Feb 21, 2024 12:44 pm
Re: AeroVee 2.1 For Sale
by VillaAir » Tue Jan 28, 2025 7:52 pm
Where are you located?
Just out of curiosity, what engine did you put in?
Greg
Just out of curiosity, what engine did you put in?
Greg
- VillaAir
- Posts: 19
- Joined: Tue Sep 06, 2022 8:17 pm
Re: AeroVee 2.1 For Sale
by Bryan Cotton » Tue Jan 28, 2025 8:33 pm
I think Jeff is in Kansas.
https://www.barnstormers.com/classified ... ngine.html
https://www.barnstormers.com/classified ... ngine.html
Bryan Cotton
Poplar Grove, IL C77
Waiex 191 N191YX
Taildragger, Aerovee, acro ailerons
dual sticks with sport trainer controls
Prebuilt spars and machined angle kit
Year 2 flying and approaching 200 hours December 23
Poplar Grove, IL C77
Waiex 191 N191YX
Taildragger, Aerovee, acro ailerons
dual sticks with sport trainer controls
Prebuilt spars and machined angle kit
Year 2 flying and approaching 200 hours December 23
-
Bryan Cotton - Posts: 5537
- Joined: Mon Jul 01, 2013 9:54 pm
- Location: C77
Re: AeroVee 2.1 For Sale
by Wanttobuild25 » Wed Jan 29, 2025 10:44 am
Located at KOJC, Olathe, KS (South side of Kansas City Metro Area).
Currently flying with a 2850 Corvair engine. With me and full fuel I’m inside the forward end of the CG range. The crankshaft prop flange is located same forward/aft, up/down as the VW engine. About halfway through Phase I now, I’ll post a lot more when Phase I is done.
Currently flying with a 2850 Corvair engine. With me and full fuel I’m inside the forward end of the CG range. The crankshaft prop flange is located same forward/aft, up/down as the VW engine. About halfway through Phase I now, I’ll post a lot more when Phase I is done.
- Wanttobuild25
- Posts: 12
- Joined: Wed Feb 21, 2024 12:44 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests
