Skippydiesel wrote:Hi Gary,
I like your oil cooler installation - I am going the same way. Any over/under cooling in this "department"?
If possible, a photo showing your exit air design, would be very helpful.
Your airspeed/fuel consumption is great - hope mine will be similar.
The 2 metal elbow oil lines - Rotax ? or other?
Skippydiesel wrote:Gary,
I have found in Rotax parts catalogue, Section 79-20-00, page 9, Oil Radiator;Part Number 956615 - Screw Connection Set Straight (Correct?)
AND
Part Number 956585 - Screw Connection Set Bent (Correct?)Is PN 956585 also the fitting on your oil pump?
Users browsing this forum: No registered users and 21 guests