Brand New Prince Prop De-Laminating.. Issue Resolved

Anything related to props

Re: Brand New Prince Prop De-Laminating.. Issue Resolved

Postby 142YX » Fri May 03, 2013 7:45 pm

I sent mine back on Monday too. I expect to get my new one in a week or two.

fastj22 wrote:I had painted the crush plate/nose cone but it chipped when I torqued the bolts. So I stripped all the paint off it. WIll leave it naked.


What did you use to paint your spinner that did not give you good results? I was hoping to paint mine..
Waiex # 142 - Taildragger, Jabiru 3300
First Flight - July 13th, 2015
450 hours and counting..
User avatar
142YX
 
Posts: 263
Joined: Thu Sep 01, 2011 10:18 pm

Re: Brand New Prince Prop De-Laminating.. Issue Resolved

Postby fastj22 » Sat May 04, 2013 8:29 am

The same auto paint I used for the rest of the plane. The only problem areas were under the bolt heads. As I tightened the bolts, the paint gave way under them leaving unsightly chips. If I did it again, I'd mask off the surfaces.

John Gillis
SEL Private, Comm Glider, Tow pilot (Pawnee Driver)
Waiex N116YX, Jabiru 3300, Tail dragger,
First flight, 3/16/2013. 403 hours and climbing.
Home: CO15. KOSH x 5
Flying a B-Model Conversion (Super Bee Baby!)
User avatar
fastj22
 
Posts: 1594
Joined: Sun Aug 21, 2011 5:56 pm
Location: Mile High

Previous

Return to Propellers

Who is online

Users browsing this forum: No registered users and 1 guest