Hydraulic Brake Stick Master Cylinder

[kmacht]

I decided to bite the bullet and bought hydraulic brakes for my sonex. At the same time I bought the master cylinder that goes on the stick and has a hand grip lever you pull to activate the barkes. This is the same one that Tracy O'brien and Hegar both sell. The problem I am running into is that the lever on the m/c is huge. I know I have seen this installed in other peoples planes but can't find where. I vaguely remember someone either cutting it down shorter or modifying it somehow. Can anyone point me in the direction of a build log that has used the stick mounted m/c before? I searched for about an hour last night and can't find the pictures I remember.

Ketih

[Rodney]

http://www.greatplainsas.com/schbrakes.html

Don't know for sure if this is what your looking for -

Regards
Rodney

[Mike53]

Joystick1.jpg (58.93 KiB) Viewed 3277 times

I think this is what he refers to?
Actually looks pretty good and useable :idea:

[kmacht]

That what I have. Is that your setup Mike? The reason I am asking is because I don't I can go quite as low as that is mounted on the stick. The cylinder on the bottom hits the spar tunnel at full forward deflection. I know I saw somewhere were somebody modified the actual pull lever so that it was shorter and you can mount the whole assembly higher on the stick. I just haven't been able to find it.

Keith
#554

[Mike53]

That what I have. Is that your setup Mike? The reason I am asking is because I don't I can go quite as low as that is mounted on the stick. The cylinder on the bottom hits the spar tunnel at full forward deflection. I know I saw somewhere were somebody modified the actual pull lever so that it was shorter and you can mount the whole assembly higher on the stick. I just haven't been able to find it.

Keith
#554

Hi Kieth.
No it's not mine.Is it not possible for you to modify the control stick with a slight dog leg so that the existing lever handle can be kept intact?
I have no way of knowing how much of an adjustment you need but that handle looks like its cast and then plated in which case cutting a section out and welding it back together might be more problematic then altering your stick.