Sonex 1517 first flight

Post stories/images of the first flight of your Sonex, Waiex, Xenos, or Onex here.

Re: Sonex 1517 first flight

Postby n982sx » Sun Oct 11, 2015 9:22 am

Robbie,

With the great weather yesterday, I thought you might give it a go. Congratulations again. Welcome to the club of flying Chicago area Sonex's. It's a nice fleet.
Bob Meyers

Built and Flying Sonex N982SX http://n982sx.com
Built and Flying RV-14 N626KM http://n626km.com
User avatar
n982sx
 
Posts: 113
Joined: Tue Sep 03, 2013 11:45 pm
Location: Chicago, IL

Re: Sonex 1517 first flight

Postby Sonex1517 » Sun Oct 11, 2015 9:25 am

As promised, a longer post....

I had recently completed two separate transition training sessions in preparation for my first flight. So after my FSDO inspection last Thursday, I did not want to wait too long for my first flight. I wanted to do it while I still was fresh from the training.

The forecast for Saturday showed light winds in the morning, so I decided I would see what the morning brought and possibly go fly. When I got to the airport at 7:15 a.m. A fog bank was just burning off, and the winds were calm. My wife and son soon arrived, so I spent a couple of moments with them, then climbed in and fired up the Sonex.

The entire time, I kept telling myself I did not have to fly, and if I did I should expect an emergency abort on my first takeoff. But things felt good, the airplane seemed ready, and the engine was running fine.

A brief run up showed no surprises, so, I taxied out and called ground.

I felt calm and collected, determined, and focused. I told the ground controller this was a first flight, remaining over the airport and climbing to 2500. She told me to expect a Runway 27, so I called the tower. With no traffic, I was cleared for takeoff immediately. The engine was warm, so I taxied out to the runway.

I took a deep breath as I pulled on to the runway, lined up on the centerline, and slowly advanced the throttle. It was cool and calm, and my turbo powered AeroVee came up smoothly and I was off the runway in less than 800 feet. I instinctively kicked in left rudder, hearing Mike Farley and Joe Norris in my head....

Keeping the nose down, I made a small bank left and right and verified I had no control issues. So, I continued the climb gently, and the tower gave me a choice of left or right turn. I chose right, as the northwest corner of the airport is mostly empty and gives easy access to three runways (four if you count the unused grass strip).

The Sonex was a dream to fly and after years of thinking about this, it was an incredible feeling to know I was flying what, until now, had been a project. Now she is an airplane, flying. Wow....

I climbed to 2500 feet and stayed right over the northwest corner of the airport. Gentle banks each way, sped up to easy cruise, then slowed down. No changes in flight characteristics.

After about 15 minutes or so, I called tower and asked to come back in. I was given the right downwind to 27, so I circled down slowly to pattern altitude. Once in the pattern, I just slowed the Sonex down as Joe Norris drilled into my head. A notch of flaps abeam my touchdown point, easy power reductions, then a second notch of flaps on base. I stayed close and made a gently curving turn in to be certain I could make the runway if the engine quit.

In short final, I pulled the nose back to slow further, continued to ease the power off as I approached the runway, then put her in the three point altitude as I felt the time was right. It must have been the right place, because I landed with the gentlest of bounces, keeping the stick back in my lap.

On rollout, as I slowed, the engine stopped. That got my attention! It appears my idle needs adjustment and may possibly be too rich. Not sure yet. (The engine never hiccuped once or ran rough in flight)

I coasted off the runway and ended up pushing it to the ramp where my wife and son were waiting. After a lot of hugging and high fives, I climbed back in, fired her up, and taxied back to the hangar. No major surprises were found in a post flight inspection.

All in all a huge success and I am still amazed that I finally flew her.
Robbie Culver
Sonex 1517
Aero Estates (T25)
First flight 10/10/2015
375+ hours
Jabiru 3300 Gen 4
Prince P Tip
Taildragger
N1517S
User avatar
Sonex1517
 
Posts: 1670
Joined: Fri Jun 03, 2011 10:11 am
Location: T25 Aero Estates, Frankston, TX

Sonex 1517 first flight

Postby Sonex1517 » Sun Oct 11, 2015 9:58 am

A few screen shots from one of the GoPro angles.


Robbie Culver
Sonex 1517
Chicagoland
Tails and Wings complete - finishing fuselage.
N1517S reserved
Attachments
ImageUploadedByTapatalkHD1444571864.883308.jpg
ImageUploadedByTapatalkHD1444571864.883308.jpg (54.37 KiB) Viewed 5958 times
ImageUploadedByTapatalkHD1444571856.698217.jpg
ImageUploadedByTapatalkHD1444571856.698217.jpg (46.1 KiB) Viewed 5958 times
ImageUploadedByTapatalkHD1444571847.743310.jpg
ImageUploadedByTapatalkHD1444571847.743310.jpg (44.77 KiB) Viewed 5958 times
ImageUploadedByTapatalkHD1444571835.947623.jpg
ImageUploadedByTapatalkHD1444571835.947623.jpg (53.26 KiB) Viewed 5958 times
ImageUploadedByTapatalkHD1444571821.962960.jpg
ImageUploadedByTapatalkHD1444571821.962960.jpg (52.55 KiB) Viewed 5958 times
Robbie Culver
Sonex 1517
Aero Estates (T25)
First flight 10/10/2015
375+ hours
Jabiru 3300 Gen 4
Prince P Tip
Taildragger
N1517S
User avatar
Sonex1517
 
Posts: 1670
Joined: Fri Jun 03, 2011 10:11 am
Location: T25 Aero Estates, Frankston, TX

Re: Sonex 1517 first flight

Postby Concorde » Sun Oct 11, 2015 10:56 am

Congratulations.
I hope to be there in two years.
Ben
Sonex # 1684
Tri-Gear, Dual Control
Rotax 912uls
N379BS reserved.
Concorde
 
Posts: 176
Joined: Sun Aug 10, 2014 2:11 pm
Location: North Carolina

Re: Sonex 1517 first flight

Postby hickej » Sun Oct 11, 2015 11:43 am

I am so incredibly happy for you! Welcome to the club... and nice landing attitude
-Jim Hicke
hickej
 
Posts: 146
Joined: Tue Dec 24, 2013 2:20 am

Re: Sonex 1517 first flight

Postby Rynoth » Sun Oct 11, 2015 1:26 pm

Great recap Robbie, enjoyed reading it! Exciting!
Ryan Roth
N197RR - Waiex #197 (Turbo Aerovee Taildragger)
Knoxville, TN (Hangar at KRKW)
My project blog: http://www.rynoth.com/wordpress/waiex/
Time-lapse video of my build: https://www.youtube.com/watch?v=Q8QTd2HoyAM
User avatar
Rynoth
 
Posts: 1308
Joined: Fri Jul 26, 2013 1:32 pm
Location: Knoxville, TN

Re: Sonex 1517 first flight

Postby GordonTurner » Sun Oct 11, 2015 4:17 pm

Congratulations Robbie,

More motivation for the rest of us coming up behind. Thanks for sharing.

Gordon
Waiex 158 New York. N88YX registered.
3.0 Liter Corvair built, run, and installed.
Garmin panel, Shorai LiFePo batteries.
GordonTurner
 
Posts: 667
Joined: Tue Feb 21, 2012 1:14 am
Location: NY, NY

Re: Sonex 1517 first flight

Postby Sonex1462 » Sun Oct 11, 2015 4:38 pm

Congratulations Robbie!!!
That is awesome!
Thanks for sharing your story with the rest of rest. Your success provides motivation for the rest of us.
John Stewart
Sonex 1462
Kit, Aerovee, Tri Gear, ST Controls

Website: http://stewartaircraft.net
Sonex1462
 
Posts: 135
Joined: Thu May 16, 2013 8:08 pm

Re: Sonex 1517 first flight

Postby avee8r » Sun Oct 11, 2015 8:04 pm

Congratulations Robbie!
Its amazing you actually had time to tend to the Sonex Foundation, take the pictures you do, live a life, AND build the plane.
Enjoy the next phase of your journey.
Happy Landings
John
N50NX
avee8r
 
Posts: 97
Joined: Sun Aug 12, 2012 11:30 am

Sonex 1517 first flight

Postby Sonex1517 » Sun Oct 11, 2015 11:01 pm

John

I confess to being overbooked the past couple of years, and am looking forward to backing off on the pace....a lot.


Robbie Culver
Sonex 1517
Chicagoland
Tails and Wings complete - finishing fuselage.
N1517S reserved
Robbie Culver
Sonex 1517
Aero Estates (T25)
First flight 10/10/2015
375+ hours
Jabiru 3300 Gen 4
Prince P Tip
Taildragger
N1517S
User avatar
Sonex1517
 
Posts: 1670
Joined: Fri Jun 03, 2011 10:11 am
Location: T25 Aero Estates, Frankston, TX

PreviousNext

Return to First Flights!

Who is online

Users browsing this forum: No registered users and 0 guests