shimming engine

Discussion of the Aerovee kit engine.

shimming engine

Postby kmwoody » Sun Jul 27, 2014 1:44 pm

OK I am confused once again by Sonex instructions. My engine is sagging so I am looking at shimming it.

Aerovee 2.1 manual page 39 states that parts required include - 3/8" ID x 1.25" OD Fender Washer (Qty. 16), ACV-Z01-40.
It also states - "A minimum of two ACV-Z01-40 washers (1/8" thick total, minimum) must be placed against the front bushing.

Being that the Engine Mount Pin is 3/8" diameter, wouldn't the 3/8" washers ride over the pin by minimum 1/8" and compress the bushings?

OK now the Sonex plans call for 1/4" ID x 1" OD x 1/8" Thick Washers.

Again being that the Engine Mount Pin is 3/8" diameter, wouldn't the 1/4" diameter washers contact the pin and compress the bushings only to the end of the pin?

Please tell me what I am missing or the proper install to use.

Thanks!
I plan to be in Oshkosh on Thursday.

Ken W
Sonex 959
kmwoody
 
Posts: 107
Joined: Mon Mar 24, 2014 8:14 pm

Return to Aerovee

Who is online

Users browsing this forum: No registered users and 60 guests