random user submitted photo
ACV-M01-17 Intake Manifold Spacer Plate
2 posts
• Page 1 of 1
ACV-M01-17 Intake Manifold Spacer Plate
by Bryan Cotton » Mon Apr 22, 2024 3:47 pm
Hey all,
Can anyone tell me the thickness of the manifold spacer plate? I want to make a couple matched to my Great Plains manifolds. When I last had the manifolds off, I observed that the Aeroconversions and GPAS manifold inlets had about the same height when sitting on the table. I'm hoping to try them out and want them to line up with the existing holes in the baffles.
Can anyone tell me the thickness of the manifold spacer plate? I want to make a couple matched to my Great Plains manifolds. When I last had the manifolds off, I observed that the Aeroconversions and GPAS manifold inlets had about the same height when sitting on the table. I'm hoping to try them out and want them to line up with the existing holes in the baffles.
Bryan Cotton
Poplar Grove, IL C77
Waiex 191 N191YX
Taildragger, Aerovee, acro ailerons
dual sticks with sport trainer controls
Prebuilt spars and machined angle kit
Year 2 flying and approaching 200 hours December 23
Poplar Grove, IL C77
Waiex 191 N191YX
Taildragger, Aerovee, acro ailerons
dual sticks with sport trainer controls
Prebuilt spars and machined angle kit
Year 2 flying and approaching 200 hours December 23
-
Bryan Cotton - Posts: 5056
- Joined: Mon Jul 01, 2013 9:54 pm
- Location: C77
Re: ACV-M01-17 Intake Manifold Spacer Plate
by Area 51% » Mon Apr 22, 2024 4:26 pm
The Aeroconversions plates are .250.
The Great Plains are .180.
The Great Plains are .180.
- Area 51%
- Posts: 733
- Joined: Thu Feb 18, 2016 7:57 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: guibrites and 8 guests
