SonexBuilders.net

Evening Fellow Builders

Not sure I can bring myself to to mount the rudder cable fairings on the outside of the Skin.

I was thinking of using epoxy to mount a few nut plates on the back side of the fairing and install them on the inside of the skin with a flat head machine screw.

Has anyone done anything similar?

Make them out of aluminum and then you don't have to hide them.
viewtopic.php?f=39&t=578&start=1020

I know some of you like to make every part and I commend that. But these are cheap enough and can be attached with some grey RTV or glue ...

https://www.aircraftspruce.com/catalog/ ... irings.php

Dale
3.0 Corvair/Tailwheel

Bryan Cotton wrote:Make them out of aluminum and then you don't have to hide them.
http://www.sonexbuilders.net/viewtopic. ... start=1020

Thanks Bryan. That was on my list to consider.

daleandee wrote:I know some of you like to make every part and I commend that. But these are cheap enough and can be attached with some grey RTV or glue ...

https://www.aircraftspruce.com/catalog/ ... irings.php

Dale
3.0 Corvair/Tailwheel

Another good option. Thank you Dale.