random user submitted photo
Chamfering the Rudder Drive Horn
1 post
• Page 1 of 1
Chamfering the Rudder Drive Horn
by BobDz » Mon Oct 09, 2023 9:42 am
Rock, paper, scissors, carbide, aluminum.
Carbide wins.
To chamfer the rudder drive horn, I used a trim router with a carbide tipped chamfer bit. The end result was a very nice 45 degree chamfer that only required light sanding. The whole process took less than five minutes.
I'm pretty sure that I will be using the trim router again during construction.
Carbide wins.
To chamfer the rudder drive horn, I used a trim router with a carbide tipped chamfer bit. The end result was a very nice 45 degree chamfer that only required light sanding. The whole process took less than five minutes.
I'm pretty sure that I will be using the trim router again during construction.
- Attachments
-
Bob Dz...
Sonex B, Tri-gear
(technically within walking distance of Sonex)
N624DZ (reserved)
Plans exist to eliminate confusion, not create it.
Sonex B, Tri-gear
(technically within walking distance of Sonex)
N624DZ (reserved)
Plans exist to eliminate confusion, not create it.
- BobDz
- Posts: 259
- Joined: Mon Oct 02, 2023 3:44 pm
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests
