SonexBuilders.net

Posted: **Thu Nov 13, 2014 6:28 pm**

Hello,

Is it best to use a drill press to ream pilot drilled holes?

Any suggestions where to get reasonably priced reamer bits?

I found a .6980" reamer bit at Grainger for > $90.

Thanks,
Don

Posted: **Thu Nov 13, 2014 8:33 pm**

I have bought several reamers from Enco.
http://www.use-enco.com/CGI/INPDFF?PMPAGE=1126

It is always better to use a drill press if you can, unless you are a Terminator.

Posted: **Thu Nov 13, 2014 9:23 pm**

I guess I haven't got to that step yet...what the hell is a flanged bearing pivot?

Posted: **Thu Nov 13, 2014 10:14 pm**

Thanks for the informative link Bryan.

Re:

GordonTurner wrote:I guess I haven't got to that step yet...what the hell is a flanged bearing pivot?

ONX-W21-04 Bellcrank Pivot.

;) Getting there: Page ONX-W21 (Detail of-03 Aileron Pivot Assembly)

Posted: **Fri Nov 14, 2014 4:58 pm**

Don, I did not ream, just pressed the bearings in place.

Paul, OneX 76

SonexBuilders.net

Ream Aileron Paddle flanged pivot bearing hole?

Ream Aileron Paddle flanged pivot bearing hole?

Re: Ream Aileron Paddle flanged pivot bearing hole?

Re: Ream Aileron Paddle flanged pivot bearing hole?

Re: Ream Aileron Paddle flanged pivot bearing hole?

Re: Ream Aileron Paddle flanged pivot bearing hole?